Miami-Dade WASD / Rex Utilities water: quality report, contact and service area

Average above 4.0 ppt, the limit in EPA's 2024 PFAS rule (water systems must meet it by April 2029; EPA has proposed allowing until 2031)

Our systems aren't certified for PFAS.

The level shown is the average of all of the utility's results in the years shown, with results below EPA's reporting level counted as zero. The highest single result and the number of samples in which it was detected are shown with each level. Each of these averaged above 4.0 ppt across all of the utility's samples, with results below the reporting level counted as zero. EPA judges compliance on a running annual average at each sampling point, so our combined average is a guide, not a compliance result. Under EPA's 2024 PFAS rule, water systems must meet the PFOA and PFOS limits (4.0 ppt each) by April 2029; in May 2026 EPA proposed allowing extensions to April 2031. Results before then are monitoring data, not violations.

Public data from EPA UCMR 5, 2025. It isn't a test of your tap, and your water can differ. Last checked against the Federal Register: October 25, 2026.

Lead

Lead: 1 ppb (90th percentile of tap samples, January to December 2023). EPA action level (90th percentile): 15 ppb.

Lead is measured at the tap in homes selected because they are most likely to have lead plumbing. EPA says lead in drinking water mainly comes from pipes, solder and fixtures in service lines and buildings, not from the water source. Your home's plumbing matters more than the utility's number. EPA's goal (MCLG) for lead is zero.

California's public health goal for lead is 0.2 ppb.

If your home is older or may have a lead service line, ask your utility (it must keep a service-line inventory) or have your tap tested by a state-certified lab.